|
|
 |
| Installation Instructions |
|
- DO NOT PUT SENSOR ON TIRES! First, position the Monitor temporarily at the desired mounting location (so it can be moved for best signal reception). Plug the power cord into the cigarette lighter socket (or use optional hard wire). When power is on, the green light below the "SET" button flashes once every 5 seconds.
- Placing the system in "Program Mode": Press and Hold the "PROG" Button for 5 seconds; the small green power light will stop flashing and become a continuous green light. The front left (driver’s side) tire location light on the Monitor display will begin to flash. You are now in Program Mode. (The words "NO SEN SOR" will scroll across the digital display on a new installation.) Note: The system will exit the "Program Mode" if there is no activity for 10 minutes. If this happens, simply place the Monitor back into the "Program Mode" when you are ready to continue.
- Screw a Sensor onto the valve stem of the tire at the location denoted by the flashing location light. TIGHTEN FIRMLY BY HAND. USING A TOOL TO TIGHTEN CAN DAMAGE THE Sensor AND VOIDS THE Warranty. HOLD VALVE STEM WITH HAND OR PLIERS IF NECESSARY. Listen for the "release" of air when screwing on the Sensor. Turn Sensor approximately two (2) full turns after hearing the air release.
- With the Sensor screwed on, the Monitor will display a Pressure Reading for that tire. This can take up to 60 seconds. This initial pressure reading sent from the Sensor is your BASELINE pressure. (The Sensor will alert at a pressure loss of 12.5% below this initial reading and again at 25% low.)
- Once a pressure reading is displayed, press and hold the "PROG" button (hold for only 1 to 2 seconds) until the flashing wheel location light on the Monitor moves to the NEXT TIRE LOCATION. This locks in that Sensor and its code to that wheel position in the Monitor. If this is not a location you want to install a Sensor on, use the "UP" or "DOWN" arrow buttons to move the flashing light to the desired location and screw a Sensor onto that tire.
- After installing the last Sensor, and it displays a pressure reading, YOU MUST AGAIN PRESS THE "PROG" BUTTON UNTIL THE RED FLASHING LOCATION LIGHT MOVES TO THE NEXT TIRE LOCATION. It is OK if this is a tire location that already has a Sensor installed - it will simply display 3 dashes (---). To go out of "Program Mode" and into "Normal Mode" press the "SET" button. The system is now installed and operating.
- Complete a permanent installation of the Monitor with provided Velcro or purchased mounting accessories.
|
| |
| Previous | Next |
| |
| Dealer/Rep Inquiries Welcomed! - Call 800-521-6820! |
|
|
| To turn the system Off, merely unplug it. However, it is advisable to leave the Monitor ON at all times unless storing vehicle for more than 30 days. |
|
 |
