• When in Normal Mode –Pushing and/or holding "ON" button will light up all tire locations that have been programmed.
• When in Program Mode -- Pushing "ON" button exits Program Mode.

"F/B" Button – (when separating a vehicle from a tow)

When separating the main vehicle from the tow, push F/B button.  All tires with Sensors will light and display on the Monitor.  Press F/B button until just the vehicle you want to use is active (lit on the Monitor display).  System will Monitor that vehicle only.  Use the F/B button to reattach both vehicles.  Press F/B button until vehicles you want active are lit.  (Press F/B button until all programmed lights are lit putting system in Monitoring mode for both vehicle and tow.) 

"SET" Button

Entering Program Mode from Normal Mode: Hold "SET" button for approx 5 sec. until the green light below the "ON" button remains on.

Deleting a Single Sensor/Location: With a tire location selected, holding "SET" button for approx. 10 seconds (while in "Normal Mode"), will delete that tire location from the active list. Note:  After approx. 5 seconds, green light will remain on; continue to hold "SET" until the green light and the selected tire location turn off (approx. 10 seconds).  Display will show "Del". Deletion of Sensor is complete. 

Deleting all Sensors/Locations at one time: All installed Sensors can be deleted simultaneously by holding the "SET" button for 45 seconds.  (When holding SET button, the following will happen: After 5 seconds, the green light will go solid; hold for another 10 seconds and "DEL" appears on Monitor face; continuing to hold for 30 seconds deletes all readings and Monitor to display "No Sen Sor".)  

"UP" & "DOWN" Buttons

In Both Normal and Program Mode – Push "UP" arrow to rotate selected tire location clockwise. Push "DOWN" arrow to rotate selected tire location counterclockwise.